Home ›› Serial & Wireless Connectivity ›› ZigBee®/ Mesh / Point-to-Multipoint Modules

XBee-PRO® 900HP

Long Range 900 MHz OEM RF Module


  • Superior LOS range of up to 28 miles with high-gain antenna
  • Simplified AT command set and advanced XBee API
  • Over-the-air firmware updates
  • Software-selectable channel mask for interference immunity
  • Advanced sleep modes: sleeping routers, pin sleep, cyclic sleep


Hardware XBee-PRO 900HP Programmable XBee-PRO 900HP
Processor ADF7023 transceiver, Cortex-M3 EFM32G230 @ 28 MHz
Programmable includes: Freescale MC9S08QE32
Frequency Band 902 to 928 MHz, software selectable channel mask for interference immunity
Antenna Options Wire, U.FL and RPSMA
RF Data Rate 10 Kbps or 200 Kbps
Indoor/Urban Range 10 Kbps: up to 2000 ft (610 m); 200 Kbps: up to 1000 ft (305 m)
Outdoor/ Line-Of-Sight Range 10 Kbps: up to 9 miles (14 km); 200 Kbps: up to 4 miles (6.5 km) ( w/ 2.1 dB dipole antennas)
Transmit Power Up to 24 dBm (250 mW) software selectable
Receiver Sensitivity -101 dBm @ 200 Kbps, -110 dBm @ 10 Kbps
Data Interface UART (3V), SPI
GPIO Up to 15 Digital I/O, 4 10-bit ADC inputs, 2 PWM outputs
Networking Topologies DigiMesh, Repeater, Point-to-Point, Point-to-Multipoint, Peer-to-Peer
Spread Spectrum FHSS (Software Selectable Channels)
Memory N/A 32 KB Flash / 2 KB RAM
CPU/Clock Speed N/A HCS08 / Up to 50.33 MHz
Supply Voltage 2.1 to 3.6 VDC 2.4 to 3.6 VDC
Transmit Current 215 mA 229 mA
Receive Current 29 mA 44 mA
Sleep Current 2.5 uA 3 uA
Regulatory Approvals
IC (Canada) 1846A-XB900HP
C-Tick (Australia) Yes
Anatel (Brazil) Yes
IDA (Singapore) Yes
IFETEL (Mexico) Yes

XBee-PRO 900HP embedded modules provide best-in-class range wireless connectivity to devices. They take advantage of the DigiMesh® networking protocol, featuring dense network operation and support for sleeping routers, and are also available in a proprietary point-to-multipoint configuration. Supporting RF line-of-sight ranges up to 28 miles (with high-gain antennas), and data rates of up to 200 Kbps, these modules are ideal for extended-range applications requiring increased data throughput.

The XBee-PRO 900HP requires no programming and can be configured easily using Digi’s free XCTU software or via a simplified AT command set. XBee modules are pre-certified for use in multiple countries, further reducing development costs and time to market.

XBee® modules are easy to use, share a common hardware footprint and are available in a variety of different protocols, enabling users to substitute one XBee for another with minimal development time and risk.

Have Questions? Call +603 7887 6820 or email sales@anewtech.com.my