Home ›› Industrial Communication ›› Wireless Access Point/Router

O-IGAP-820 / IGAP-820+

Industrial IEEE 802.11 ac/g/n wireless access point with 2x10/100/1000 Base-T(X)

Features

  • High Speed Air Connectivity: WLAN interface support up to 1.3Gbps link speed
  • Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
  • Support X-Roaming < 60 ms
  • Support wireless load balance
  • Support MAC Filter
  • Support Long Distance Air Connectivity
  • Provide Digital Input and Digital Output
  • Support AP/Client Mode
  • Support Multiple-SSID to 4 SSID
  • Switch Mode Supported: Daisy Chain support to reduce usage of switch ports
  • Wireless connecting status monitoring
  • Secured Management by HTTPS
  • Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper
  • Rigid IP-30 housing design
  • DIN-Rail and Wall-mount enabled

Specification

Model O-IGAP-820 O-IGAP-820+
Physical Ports  

10/100/1000 Base-T(X) Ports in RJ45 Auto MDI/MDIX

 2
5-Pin Terminal Block

2(DI x 4 and DO x 4) :
Dry Contact:
       On: short to GND, Off: open
Wet Contact (DI to COM/GND):
        On: 0 to 3VDC, Off: 10 to 30VDC

Antenna Connector

3
PoE P.D Port  -

Present at ETH2
Fully compliant with IEEE 802.3af Power Device specification
Over load & short circuit protection
Isolation Voltage: 1000 VDC min.
Isolation Resistance : 108 ohms min

WLAN interface  
Operating Mode AP/Client
Antenna Connector Reverse SMA Female
Radio Frequency Type OFDM, DSSS
Modulation

IEEE802.11a: OFDM
IEEE802.11b: CCK/DQPSK/DBPSK
IEEE802.11g: OFDM
IEEE802.11n: BPSK, QPSK, 16-QAM, 64-QAM
IEEE802.11ac: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM

Frequency Band

America/FCC: 2.412~2.462 GHz
                     5.180~5.240 GHz & 5.745~5.825 GHz
Europe CE/ETSI: 2.412~2.472 GHz
                          5.180~5.240 GHz

Transmission Rate

802.11b: 11, 5.5, 2, 1 Mbps;
802.11g: 54, 48, 36, 24, 18, 12, 9, 6 Mbps
802.11n: up to 450Mbps
802.11ac : up to 1.3Gbps

Transmit Power

802.11a: 15dBm ± 2dBm@54Mbps
802.11b: 18dBm ± 2dBm@11Mbps
802.11g: 15dBm ± 2dBm@54Mbps
802.11gn HT20: 13dBm ± 2dBm @MCS7
802.11gn HT40: 13dBm ± 2dBm @MCS7
802.11an HT20: 13dBm ± 2dBm @MCS7
802.11an HT40: 12dBm ± 2dBm @MCS7
802.11ac VHT80: 10dBm ± 2dBm @MCS9

Receiver Sensitivity

802.11a : -65dBm ± 2dBm@54Mbps
802.11b : -76dBm ± 2dBm@11Mbps
802.11g : -65dBm ± 2dBm@54Mbps
802.11gn HT20:-64dBm ± 2dBm@MCS7
802.11gn HT40:-61dBm ± 2dBm@MCS7
802.11an HT20:-64dBm ± 2dBm@MCS7
802.11an HT40:-61dBm ± 2dBm@MCS7
802.11ac VHT80:-51dBm ± 2dBm@MCS9

Encryption Security

WEP: (64-bit ,128-bit key)
WPA/WPA2 PSK :TKIP and AES encryption (802.11i)
802.1X/RADIUS Authentication supported

Wireless Security SSID broadcast disable and enable
Protocol Support  
Protocol ARP,BOOTP, DHCP, DNS, HTTP, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP, RSTP
LED Indicators  
Power Indicator

3 x LEDs, PWR1(2)(PoE)/Ready:
Red On : Power is on and booting up
Green On : Power is on and functioning Normal

10/100/1000TX RJ45 Port Indicator

2 x LEDs, Green for port Link/Act at 1000Mbps
                Amber for port Link/Act at 100Mbps.

WLAN LED

Green Solid On: RF on, Blink: data transmitting
Green for WLAN Strength: 1<25%, 2<50%, 3<75%, 4<100%

Fault 1 x LED, Red for Ethernet link down or power down indicator
Fault contact  
Relay Relay output to carry capacity of 1A at 24VDC
Power  
Redundant Input Power Dual DC inputs. 12~48VDC on 6-pin terminal block
Power Consumption (Typ.) 7.5W 8.5W
Overload Current Protection Present
Reverse Polarity Protection Present on terminal block
Physical Characteristic  
Enclosure IP-30
Dimension (W x D x H) 74.3(W) x 109.2(D) x 153.6(H) mm (2.93 x 4.3 x 6.05 inch.)
Weight (g) 1150 g 1155 g
Environmental  
Storage Temperature -40 to 85°C (-40 to 185°F)
Operating Temperature -25 to 70°C (-13 to 158°F)
Operating Humidity 5% to 95% Non-condensing
Regulatory approvals  
EMI FCC Part 15, CISPR (EN55022) class A
EMS

IEC61000-4-2 (ESD), IEC61000-4-3 (RS), IEC61000-4-4 (EFT), IEC61000-4-5 (Surge), IEC61000-4-6 (CS), IEC61000-4-8, IEC61000-4-11

Shock IEC60068-2-27
Free Fall IEC60068-2-32
Vibration IEC60068-2-6
Safety EN60950-1
O-IGAP-820 series is a reliable WLAN Access Point with 2 Ethernet Gigabit ports and IEEE 802.11 ac/g/n wireless module. It can be configured to operate in AP/Client mode. O-IGAP-820 / IGAP-820+ is configurable by WEB interface via LAN port or WLAN interface. O-IGAP-820 series provides dual Ethernet ports in switch mode, user can use Daisy Chain to reduce the usage of Ethernet switch ports. In addition, O-IGAP-820+ also provides P.D. feature on ETH2 port which is fully compliant with IEEE802.3af PoE P.D. specification.

Have Questions? Call +603 7887 6820 or email sales@anewtech.com.my